2003 Honda Insight StandardFACTORY OEM SERVICE PROCEDURE

Engine Lubrication System

MEASUREMENT SPECIFICATION

Item Measurement Qualification Standard or New Service Limit
Engine oil Capacity Engine overhaul 3.0 L (3.2 US qt)
Oil change, including filter 2.5L(2.6USqt)
Oil change, without filter 2.3L(2.4USqt)
Oil pump Inner-to-outer rotor clearance   0.02-0.14 mm (0.001-0.006 in.) 0.18 mm (0.007in.)
Pump housing-to-outer rotor clearance   0.100-0.175 mm (0.0039-0.0069 in.) 0.20 mm (0.008 in.)
Pump housing-to-outer rotor axial clearance   0.02-0.07 mm (0.001-0.003 in.) 0.12 mm (0.005 in.)
Oil pressure with oil temperature at 176°F(80°C) At idle 70 kPa (0.7 kgf/cm2 , 10 psi) min.
At 3, 000 rpm 340 kPa (3.5 kgf/cm2 , 50 psi) min.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.