2003 Honda Insight StandardFACTORY OEM SERVICE PROCEDURE

Electrical Component Locator: Grounds

GROUNDS LOCATION

Component Component Location
G1 At center rear of engine compartment. See Figure .
G2 At left side of engine compartment. See Figure .
G3 At left side of engine compartment. See Figure .
G4 At left side of engine compartment. See Figure .
G101 At top rear of engine. See Figure .
G102 At top rear of engine. See Figure .
G201 Above right front wheelwell. See Figure .
G301 Above left front wheelwell. See Figure .
G401 Behind top of left kick panel. See Figure .
G402 Behind left side of dash. See Figure .
G403 Behind center of dash. See Figure .
G404 Behind right side of dash. See Figure .
G451 Behind right kick panel. See Figure .
G501 Under SRS unit, at front of center console. See Figure .
G502 Behind rear seats, at center of floor. See Figure .
G601 At center rear of cargo area.
G651 At left rear side of floor.
G701 At center rear of roof. See Figure .
Chapter Navigation
Return to Chapter: Electrical Component Locator
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.