2003 Honda Insight StandardFACTORY OEM SERVICE PROCEDURE

ABS Modulator-Control Unit Removal and Installation: Removal

  1. Pull up the lock (A) of the ABS modulator-control unit 25P connector (B), then disconnect the connector.
    Fig 1: Pulling Up Lock Of ABS Modulator-Control Unit 25P Connector And Torque Specifications
    G03682522Courtesy of AMERICAN HONDA MOTOR CO., INC.
  2. Disconnect the six brake lines.
  3. Remove the two 6 mm nuts.
  4. Remove the ABS modulator-control unit (C) from the bracket (D).
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.