2003 Honda Civic SiFACTORY OEM SERVICE PROCEDURE

CMP Sensor A Replacement

  1. Remove the air cleaner (see AIR CLEANER REMOVAL/INSTALLATION ).
  2. Disconnect CMP sensor (A) 3P connector.
    Fig 1: Disconnect CMP Sensor 3P Connector
    G01399517Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Remove CMP sensor from the intake camshaft side of the cylinder head.
  4. Install the sensor (A) in the reverse order of removal with a new O-ring (B).
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.