Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Honda S2000FACTORY OEM SERVICE PROCEDURE
Electrical Component Locator: Switches
SWITCHES LOCATION
| Component | Component Location |
|---|---|
| A/C Pressure Switch | On receiver drier, behind center of front bumper. |
| Back-Up Light Switch | On left side of transmission. See Figure. |
| Brake Fluid Level Switch | On master cylinder reservoir. |
| Brake Pedal Position Switch | On brake pedal support. See Figure. |
| Clutch Interlock Switch | On clutch pedal support. See Figure. |
| Clutch Pedal Position Switch | Under left side of dash. See Figure. |
| Convertible Top Disable Switch | Behind rear left side trim. |
| Hood Switch | On left front of engine compartment. |
| Parking Brake Switch | At base of parking brake lever. See Figure. |
| Radiator Fan Switch | On lower left side of radiator. |
| Trunk Lid Opener Switch | Behind rear console. |
| VTEC Oil Pressure Switch | On right front of engine. See Figure. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.