Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Honda Insight StandardFACTORY OEM SERVICE PROCEDURE
Wheel Runout Inspection
NOTE:
When measuring the front wheel runout, turn the other side of the wheel slowly by hand.
- Raise the vehicle, and support it with safety stands in the proper locations (see SAFETY STANDS ).
- Check for bent or deformed wheels.
- Set up the dial gauge as shown, and measure the axial runout by turning the wheel.
Front and rear wheel axial runout:
- Standard: 0-0.7 mm (0-0.03 in.)
- Service limit: 2.0 mm (0.08 in.)
- Reset the dial gauge to the position shown, and measure the radial runout.
Front and rear wheel radial runout:
- Standard: 0-0.7 mm (0-0.03 in.)
- Service limit: 1.5 mm (0.06 in.)
- If the wheel runout is out of specification, check the wheel bearing end play (see TURNING ANGLE INSPECTION ).
- If the bearing end play is within the specification but the wheel runout is more than the service limit, replace the wheel.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
