2002 Honda Insight StandardFACTORY OEM SERVICE PROCEDURE

Sunlight Sensor Test

WARNING: This page is about a different car, the 2006 Honda Odyssey and 2005 Honda Odyssey. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the sunlight sensor (A) from the dashboard.
    Fig 1: Removing Sunlight Sensor From Dashboard
    G03706501Courtesy of AMERICAN HONDA MOTOR CO., INC.
  2. Turn the ignition switch ON (II). Measure the voltage between the terminals with the (+) probe on the No. 4 (with automatic lighting sensor) or No. 1 (without automatic lighting sensor) terminal and the (-) probe on the No. 2 terminal with the connector connected.
    NOTE: The voltage readings will not change under the light of a flashlight or a fluorescent lamp. Voltage should be:
    • 3.6-3.7 V or more with the sensor out of direct sunlight.
    • 3.3-3.5 V or less with the sensor in direct sunlight.
  3. If the voltage is not as specified, replace the sunlight sensor (see SUNLIGHT SENSOR REPLACEMENTΒ  ).
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.