2002 Honda Insight StandardFACTORY OEM SERVICE PROCEDURE

In-car Temperature Sensor Test

WARNING: This page is about a different car, the 2006 Honda Odyssey and 2005 Honda Odyssey. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the in-car temperature sensor (see IN-CAR TEMPERATURE SENSOR REPLACEMENTΒ  ).
  2. Heat and cool the sensor by holding it in front of the dashboard center vent.
    • Measure the resistance with the system set to Max Cool.
    • Measure the resistance with the system set to Max Hot.
  3. Compare the resistance reading between the No. 1 and No. 2 terminals of the in-car temperature sensor with the specifications graph shown in Fig 1; the resistance should be within the specifications.
    Fig 1: Comparing Resistance Reading Between No. 1 And 2 Terminals Of In-Car Temperature Sensor Graph
    G03706497Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. If the resistance is not as specified, replace the in-car temperature sensor (see IN-CAR TEMPERATURE SENSOR REPLACEMENTΒ  ).
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.