Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Honda Insight StandardFACTORY OEM SERVICE PROCEDURE
DVD-ROM Replacement
WARNING: This page is about a different car, the 2006 Honda Odyssey and 2005 Honda Odyssey. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
When the DVD-ROM is re-inserted or replaced, a map matching must be done (see AFTER SERVICING PROCEDURES-MAP MATCHINGΒ
). This system uses a white label disc (possibly gray for Canada).
- Turn the ignition switch ON (II).
- Open the front cover (A) of the navigation unit (B) located under the driver's seat.
- Press the EJECT button (C).
- Remove the DVD-ROM.
- Insert the new DVD-ROM.
- Close the front cover. Do not turn the ignition switch OFF until data is downloaded to navigation unit.NOTE: After servicing, the front cover must be closed. If you start up the navigation system with the front cover open, the display will indicate. "Navigation unit door is open or No DVD Disk installed. Please check system".
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
