Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Honda Insight StandardFACTORY OEM SERVICE PROCEDURE
Section 108 (Driving Position Memory Systems (DPMS)): DTC
WARNING: This page is about a different car, the 2006 Honda Odyssey and 2005 Honda Odyssey. However, it is still accessible from the selected car via links, so may be relevant.
DTC INDEX
| DTC | Description |
|---|---|
| DTC B1802 | Power Seat Control Unit EEPROM Error |
| DTC B1805 | Power Seat Control Unit Lost Communication with Gauge Control Module (VSP/NE Message) |
| DTC B1806 | Power Seat Control Unit Lost Communication with MICU (MICU Message) |
| DTC B1807 | Power Seat Control Unit Lost Communication with MICU (DOOR SWITCH Message) |
| DTC B1808 | Power Seat Control Unit Lost Communication with Gauge Control Module (A/T Message) |
| DTC B1825 | Power Seat Slide Motor Pulse Error |
| DTC B1826 | Power Seat Front Up-down Motor Pulse Error |
| DTC B1827 | Power Seat Rear Up-down Motor Pulse Error |
| DTC B1828 | Power Seat Recline Motor Pulse Error |
| DTC B1829 | A/T P Signal and VSS Signal Mismatch |
| DTC B1836 | Power Seat Position Sensor Circuit Short |
| DTC B1837 | Driving Position Memory Recall Timeout |
| DTC B1844 | Power Seat Slide Switch Circuit Malfunction |
| DTC B1845 | Power Seat Recline Switch Circuit Malfunction |
| DTC B1846 | Power Seat Front Up-Down Switch Circuit Malfunction |
| DTC B1847 | Power Seat Rear Up-Down Switch Circuit Malfunction |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
