Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHONDA2002INSIGHT STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCETESTING & DIAGNOSISEVAP SYSTEMDTC TROUBLESHOOTINGNOTES
2002 Honda Insight Standard
DTC Troubleshooting: Notes
2002 Honda Insight StandardSECTION Notes
DTC INDEX
| DTC | Description |
|---|---|
| DTC P0442 | EVAP System Small Leak Detected (2006 model) |
| DTC P0443 | EVAP Canister Purge Valve Circuit Malfunction (2006 model) |
| DTC P0451 | FTP Sensor Circuit Range/Performance Problem (2000-2005 models) |
| DTC P0451 | FTP Sensor Circuit Range/Performance Problem (2006 model) |
| DTC P0452 | FTP Sensor Circuit Low Voltage (2000-2005 models) |
| DTC P0452 | FTP Sensor Circuit Low Voltage (2006 model) |
| DTC P0453 | FTP Sensor Circuit High Voltage (2000-2005 models) |
| DTC P0453 | FTP Sensor Circuit High Voltage (2006 model) |
| DTC P0456 | EVAP System Very Small Leak Detected (2006 model) |
| DTC P0457 | EVAP System Leak Detected/Fuel Fill Cap Loose or Missing (2006 model) |
| DTC P0496 | EVAP System High Purge Flow (2006 model) |
| DTC P0497 | EVAP System Low Purge Flow (2004-2005 models) |
| DTC P0497 | EVAP System Low Purge Flow (2006 model) |
| DTC P0498 | EVAP Canister Vent Shut Valve Circuit Low Voltage (2006 model) |
| DTC P0499 | EVAP Canister Vent Shut Valve Circuit High Voltage (2006 model) |
| DTC P1454 | FTP Sensor Circuit Range/Performance Problem (2006 model) |
| DTC P1456 | EVAP Control System Leakage (Fuel Tank System) (2000-2005 models) |
| DTC P1457 | EVAP Control System Leakage (EVAP Canister System) (2000-2005 models) |
| DTC P2422 | EVAP Canister Vent Shut Valve Close Malfunction (2006 model) |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.