Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Honda Civic SiFACTORY OEM SERVICE PROCEDURE
Variable Valve Timing Electronic Control System (VTEC) And Variable Valve Timing (VTC ) System (Hatchback)
- Component Location Index
- DTC Troubleshooting
- Notes
- DTC P0010: VTC Oil Control Solenoid Valve Malfunction
- DTC P0011: VTC System Malfunction
- DTC P0340: CMP Sensor A No Signal, DTC P0344: CMP Sensor A Intermittent Interruption
- DTC P0341: VTC Phase Gap
- DTC P1259: VTEC System Malfunction
- DTC P2646: VTEC Oil Pressure Switch Circuit Low Voltage
- DTC P2647: VTEC Oil Pressure Switch Circuit High Voltage
- VTC Oil Control Solenoid Valve Removal/Test/Installation
- CMP Sensor A Replacement
- VTEC Solenoid Valve Removal/Inspection
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
