2002 Honda Civic GXFACTORY OEM SERVICE PROCEDURE

Multiplex Communication

WARNING: This page is about a different variant/trim than selected.

To reduce the number of wire harnesses, digital signals are sent via shared multiplex communication lines rather than sending normal electrical signals through individual wires.

  • The input signals from each switch are converted to digital signals at the central processing unit (CPU).
  • The digital signals are sent from the transmitting unit to the receiving unit as serial signals.
  • The transmitted signal is converted to a switch signal at the receiving unit, and it operates the related component or monitors a switch.
  • There are exclusive communication lines between the ECM, the gauge assembly, keyless receiver unit, and the under-dash fuse/relay box.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.