Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Honda CR-V EX, AutomaticFACTORY OEM SERVICE PROCEDURE
Diagnostic Trouble Codes Troubleshooting: Notes
DIAGNOSTIC TROUBLE CODES (DTC) LIST
| DTC | Description |
|---|---|
| DTC P0010 | VTC Oil Control Solenoid Valve Malfunction |
| DTC P0011 | VTC System Malfunction |
| DTC P0340, P0344 | CMP Sensor A No Signal, CMP Sensor A Intermittent Interruption |
| DTC P0341 | VTC Phase Gap |
| DTC P1259 | VTEC System Malfunction |
| DTC P2646 | VTEC Oil Pressure Switch Circuit Low Voltage |
| DTC P2647 | VTEC Oil Pressure Switch Circuit High Voltage |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.