Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Honda Prelude Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Fuel Pressure: Odyssey
- Release fuel pressure. See FUEL SYSTEM PRESSURE RELEASE . Remove fuel pulsation damper. Connect Fuel Pressure Gauge (07406-004000A) and Fuel Pressure Gauge Adapter (07VAJ-0040100) to fuel rail where fuel pulsation damper was mounted. Reconnect negative battery terminal. Disconnect vacuum hose from fuel pressure regulator and pinch line closed. Start engine and allow to idle. If engine starts, go to next step. If engine does not start, check operation of fuel pump. See FUEL PUMP OPERATION .
- Read fuel pressure. See FUEL PRESSURE table. If engine starts and fuel pressure is as specified, go to next step. If engine starts and fuel pressure is not as specified, go to step 4.
- With engine idling, release and reconnect vacuum hose to fuel pressure regulator. Read fuel pressure. See FUEL PRESSURE table. If fuel pressure is as specified, fuel system is okay at this time. If pressure is not as specified, go to next step.
- With engine idling, disconnect vacuum hose from pressure regulator again. Pressure should rise when hose is disconnected. If pressure did not rise, replace fuel pressure regulator. If pressure rose, but readings were lower than specified, check for clogged fuel filter or fuel line leakage. If pressure rose, but readings were higher than specified, check for pinched or clogged fuel return hose.
- Relieve fuel pressure and remove gauge. Reconnect vacuum hose on pressure regulator. Reinstall fuel pulsation damper using NEW copper washers and tighten to 16 ft. lbs. (22 N.m). Start engine and check for leaks.
FUEL PRESSURE
| Application | At Idle psi (kg/cm2 ) | |
|---|---|---|
| Accord & S2000 | ||
| Vacuum Hose Disconnected & Pinched | 47-54 (3.3-3.8) | |
| Vacuum Hose Connected | 38-46 (2.7-3.2) | |
| Civic | 40-47 (2.8-3.3) | |
| CR-V & Prelude | ||
| Vacuum Hose Disconnected & Pinched | 40-47 (2.8-3.3) | |
| Vacuum Hose Connected | 31-38 (2.2-2.7) | |
| Insight | ||
| Vacuum Hose Disconnected & Pinched | 40-47 (2.8-3.3) | |
| Vacuum Hose Connected | 30-37 (2.1-2.6) | |
| Odyssey | ||
| Vacuum Hose Disconnected & Pinched | 43-50 (3.0-3.5) | |
| Vacuum Hose Connected | 36-43 (2.5-3.0) | |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
