Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Honda Odyssey LXFACTORY OEM SERVICE PROCEDURE
Right Power Sliding Door Control Unit Input Test
- Remove right rear side trim panel. See REAR SIDE TRIM PANEL under REMOVAL & INSTALLATION.
- Disconnect right power sliding door control unit 26-pin harness connector "A" and 5-pin harness connector "B". Inspect all the connectors and socket terminals to be sure the are all making good contact. See Fig 1.
- If problem exists, repair harness connector(s) as necessary and retest system. If problem does not exist, perform right power sliding door control unit input tests. See Fig 2-Fig 4 .
- If any input test is not as specified, repair indicated fault and retest system. See WIRING DIAGRAMS .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.