Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Honda S2000FACTORY OEM SERVICE PROCEDURE
Steering System
STEERING STANDARDS AND SERVICE LIMITS SPECIFICATIONS TABLE
| Item | Measurement | Qualification | Standard or New |
|---|---|---|---|
| Steering wheel | Rotational play measured at outside edge | With engine running | 0-10 mm (0-0.39 in.) |
| Starting load measured at outside edge | With engine running | 34 N (3.5 kgf, 7.7 lbf) | |
| Gearbox | Angle of rack guide screw loosened from locked position | - | 10° to 20° |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.