2000 Honda S2000FACTORY OEM SERVICE PROCEDURE

Valve Test

  1. Make sure the fuel tank is less than half full.
  2. Remove the fuel fill cap.
  3. Remove the fuel pipe cover. Disconnect the fuel tank vapor signal tube (A).
    Fig 1: Disconnecting Fuel Tank Vapor Signal Tube
    G03692873Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Disconnect the vacuum hoses (A) from the EVAP canister (B), and then plug the ports with plugs (C).
    Fig 2: Disconnecting Vacuum Hoses From EVAP Canister
    G03692874Courtesy of AMERICAN HONDA MOTOR CO., INC.
  5. Disconnect the vacuum hose (D) from the EVAP canister vent shut valve (E), and connect a commercially available vacuum pump/gauge, 0-30 in.Hg, to the EVAP canister vent shut valve.
  6. Pump the vacuum pump 80 times.
    • If the vacuum holds, go to step 7.
    • If the vacuum does not hold, go to step  9.
  7. Connect a second vacuum pump/gauge to the fuel tank vapor signal tube (A).
    Fig 3: Connecting A Second Vacuum Pump/Gauge To Fuel Tank Vapor Signal Tube
    G03692875Courtesy of AMERICAN HONDA MOTOR CO., INC.
  8. Apply vacuum (1 pump) to the fuel tank vapor signal tube (A), then check the vacuum on the pump in step  6.
  9. Disconnect the fuel tank vapor quick disconnect from the EVAP canister, then plug the port on the canister. Reapply vacuum (80 pumps).
    • If the vacuum holds, replace the fuel tank vapor control valve (see FUEL TANK VAPOR CONTROL VALVE REPLACEMENT  ).
    • If the vacuum does not hold, inspect the EVAP canister vent shut valve O-ring. If the O-ring is OK, replace the EVAP canister and repeat step  4.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.