2000 Honda S2000FACTORY OEM SERVICE PROCEDURE

Fuel Fill Cap Check

  1. Check the fuel fill cap (the cap must say "If not tightened 3 clicks check engine light may come on.")

    Is the proper fuel fill cap installed and properly tightened? 

    1. YES -  Go to step 2.
    2. NO -  Replace or tighten the cap.
  2. Check the fuel fill cap seal and the fuel fill pipe sealing surface.

    Is the fuel fill cap seal missing or damaged, or Is the fill pipe damaged? 

    1. YES -  Replace the fuel fill cap (gray or black colored cap), or the fuel fill pipe.
    2. NO -  The fuel fill cap is OK. Go to step 3.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.