Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Honda S2000FACTORY OEM SERVICE PROCEDURE
Engine Lubrication System
ENGINE LUBRICATION STANDARDS AND SERVICE LIMITS SPECIFICATIONS TABLE
| Item | Measurement | Qualification | Standard or New | Service Limit |
|---|---|---|---|---|
| Engine oil | Capacity | Engine overhaul | 5.6 L (5.9 US qt) | |
| Oil change including filter | 4.8 L (5.1 US qt) | |||
| Oil change without filter | 4.5 L (4.8 US qt) | |||
| Oil pump | Inner-to-outer rotor clearance | - | 0.02-0.014 mm (0.001-0.006 in.) | 0.20 mm (0.008 in.) |
| Pump housing-to-outer rotor clearance | - | 0.15-0.21 mm (0.006-0.008 in.) | 0.23 mm (0.009 in.) | |
| Pump housing-to-outer rotor axial clearance | - | 0.02-0.07 mm (0.001-0.003 in.) | 0.12 mm (0.005 in.) | |
| Oil pressure with oil temperature at 176°F (80°C) | At idle | 250 kPa (2.5 kgf/cm2 , 36 psi) | ||
| At 3, 000 RPM | 590 kPa (6.0 kgf/cm2 , 85 psi) | |||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.