Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Honda S2000FACTORY OEM SERVICE PROCEDURE
Starter System Circuit Troubleshooting
Special Tools Required
Alternator, Regulator, Battery & Starter tester OTC3131 Available through the Honda Tool and Equipment Program 888-424-6857
NOTE:
- Air temperature must be between 59 and 100°F (15 and 38°C) during this procedure.
- '00-05 models: After the inspection, you must reset the engine control module (ECM) using the Honda Diagnostic System (HDS) (see HOW TO RESET THE ECM ), to clear any diagnostic trouble code (DTCs).
- '06-09 models: After the inspection, you must reset the ECM using the HDS (see ECM RESET ). Otherwise, the ECM continues to stop the fuel injectors from operating.
- The battery must be in good condition and fully charged.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
