Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Honda S2000FACTORY OEM SERVICE PROCEDURE
Electrical Component Locator: Motors
MOTORS LOCATION
| Component | Component Location |
|---|---|
| ABS Modulator/Control Unit | Below master cylinder. |
| Air Mix Control Motor | On left side of heater case. See Figure . |
| Air Pump Motor | Behind left side of front bumper. |
| Blower Motor | Under right side of dash. See Figure . |
| Cruise Control Actuator | On left side of engine compartment. |
| EPS Motor | Below front center of engine compartment. |
| Mode Control Motor | On left end of heater case. See Figure . |
| Recirculation Control Motor | Under right side of dash. See Figure . |
| Windshield Washer Motor | Behind right front wheelwell, in washer reservoir. |
| Windshield Wiper Motor | On rear center of engine compartment, in air scoop. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.