Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Honda Prelude Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Ignition Control Module (ICM) Input Test (CR-V)
- Turn ignition off. Remove distributor cap, rotor and leak cover. Disconnect wires from ICM. See Figure. Turn ignition on. Check for voltage between ground and Black/Yellow wire. If battery voltage exists, go to next step. If battery voltage does not exist, check for open in Black/Yellow wire between ignition switch and ICM. See WIRING DIAGRAMS article.
- Ensure ignition is on. Check for voltage between ground and White/Blue wire. If battery voltage exists, go to next step. If battery voltage does not exist, check ignition coil operation. See INTERNAL IGNITION COIL RESISTANCE TEST (ACCORD 2.3L, CIVIC & CR-V) . Replace ignition coil as necessary. If ignition coil is okay, check for open in White/Blue wire between ICM and ignition coil.
- Disconnect PCM 25-pin connector "B". Check for continuity in Yellow/Green wire between ICM and PCM 25-pin harness connector "B" terminal No. 13. If continuity exists, go to next step. If continuity does not exist, repair open in Yellow/Green wire.
- Check for continuity between ground and PCM 25-pin harness connector "B" terminal No. 13 (Yellow/Green wire). If continuity exists, check for short to ground in Yellow/Green wire. If continuity does not exist and wiring is okay at this time, replace ICM.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.