Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Honda Prelude Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Ignition Timing: Prelude
- Set parking brake. Start engine and ensure idle speed is correct. See IDLE SPEED & MIXTUREΒ . Turn ignition off. Connect SCS Service Connector (07PAZ-0010100) to 2-pin service check connector (Green/Black wire and Red/White wire) located on right side of center console, behind access cover, next to 16-pin DLC. See Fig 6. Connect tachometer. Run engine at 3000 RPM with no electrical loads (headlights, blower motor, rear defogger, A/C and cooling fan off) and transmission in Park or Neutral. When radiator cooling fan comes on, allow engine to idle.
- Connect timing light to No. 1 spark plug wire. Check base ignition timing with no electrical loads. See IGNITION TIMING (DEGREES BTDC - RED MARK @ RPM)Β table.
- Timing marks are located on flywheel/drive plate. Remove rubber plug from window in flywheel/drive plate housing located under distributor. See Fig 11. Timing is controlled by Power Control Module (PCM). If timing is not as specified, replace PCM. See REMOVAL, OVERHAUL & INSTALLATION article. Remove SCS service connector.
IGNITION TIMING (DEGREES BTDC - RED MARK @ RPM)(1)
| Application | Specification | |||||||
|---|---|---|---|---|---|---|---|---|
| Accord | ||||||||
| 2.3L | 10-14 @ 650-750 | |||||||
| 3.0L | 8-12 @ 630-730 | |||||||
| Civic | ||||||||
| B16A2 Engine | (2)(3) 14-18 @ 650-750 | |||||||
| A/T Or CVT | (2)(3) 10-14 @ 650-750 | |||||||
| M/T | (2)(3) 10-14 @ 620-720 | |||||||
| CR-V | (3) 14-18 @ 700-800 | |||||||
| Odyssey | 8-12 @ 680-780 | |||||||
| Prelude | (3) 13-17 @ 650-750 | |||||||
| S2000 | 3-7 @ 750-850 | |||||||
|
||||||||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
