2000 Honda Odyssey EXFACTORY OEM SERVICE PROCEDURE

TCS Switch Test

  1. Remove the TCS switch (A) from the switch panel.
    Fig 1: Removing TCS Switch
    G01519896Courtesy of AMERICAN HONDA MOTOR CO., INC.
  2. Check for continuity between terminal No. 5 and No. 6. There should be continuity when the TCS switch is pushed.
    Fig 2: Checking Continuity Between Terminal No. 5 & No. 6
    G01519897Courtesy of AMERICAN HONDA MOTOR CO., INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.