2000 Honda Odyssey EXFACTORY OEM SERVICE PROCEDURE

Wheel Sensor

The wheel sensors are the magnetic contactless type. As the gear pulser teeth rotate past the wheel sensor's magnetic coil, AC current is generated. The AC frequency changes in accordance with the wheel speed. The ABS/TCS control unit detects the wheel sensor signal frequency and thereby detects the wheel speed.

Fig 1: Wheel Sensor AC Current Generation
G01519734Courtesy of AMERICAN HONDA MOTOR CO., INC.

Wheel Speed and Modulator Control (ABS)Β 

Fig 2: Wheel Sensor Operation Chart
G01519735Courtesy of AMERICAN HONDA MOTOR CO., INC.

When the wheel speed drops sharply below the vehicle speed, the outlet valve opens momentarily to reduce the caliper fluid pressure. The pump motor starts at this time. As the wheel speed is restored, the inlet valve opens momentarily to increase the caliper fluid pressure.

Wheel Speed and Modulator Control (TCS)Β 

Fig 3: Wheel Speed and Modulator Control Operation Chart
G01519736Courtesy of AMERICAN HONDA MOTOR CO., INC.

When the front wheel speed rises sharply above the vehicle speed, the TCS NC valve opens, the TCS NO valve closes, and the pump motor starts to intensify the front caliper fluid pressure. When the wheel speed drops, the front inlet valve closes momentarily to retain the front caliper fluid pressure. When the wheel speed drops further, the front outlet valve opens momentarily to reduce the front caliper fluid pressure.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.