Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Honda InsightFACTORY OEM SERVICE PROCEDURE
DTC P0116: ECT Sensor Circuit Range/ Performance Problem (2000-2005 models)
NOTE:
Before you troubleshoot, record all freeze data and review the general troubleshooting information (see GENERAL TROUBLESHOOTING INFORMATION
).
- Turn the ignition switch ON (II).
- Check the ECT SENSOR in the DATA LIST with the HDS.
Is about 176°F (80°C) or higher, or 0.86 V or less indicated?
- YES - Go to step 3.
- NO - Go to step 7.
- Note the value of the ECT SENSOR in the DATA LIST with the HDS.
- Turn the ignition switch OFF.
- Cool the engine for 1 hour.
- Check the ECT SENSOR in the DATA LIST with the HDS.
Did the ECT change 3.6°F (2°C) or more?
- YES - Intermittent failure, system is OK at this time. Check the thermostat and the cooling system.
- NO - Replace the ECT sensor.
- Note the value of the ECT SENSOR in the DATA LIST with the HDS.
- Start the engine. Hold the engine speed at 3,000 rpm without load (in Park or neutral) until the radiator fan comes on, then let it idle.
- Does the ECT SENSOR in the DATA LIST with the HDS.
Does the ECT SENSOR change 3.6°F (2°C) or more?
- YES - Intermittent failure, system is OK at this time. Check the thermostat and the cooling system.
- NO - Replace the ECT sensor.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
