2000 Honda InsightFACTORY OEM SERVICE PROCEDURE

Molding Installation

  • Be sure the alignment marks on the molding lines up with the alignment marks on the windshield.
  • Attach the molding with adhesive tape.

Adhesive tape: Thickness 0.8 mm (0.03 in.), Width 4 mm (0.16 in.)Β 

Fig 1: Attaching Molding With Adhesive Tape
G03682564Courtesy of AMERICAN HONDA MOTOR CO., INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.