Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Honda InsightFACTORY OEM SERVICE PROCEDURE
Both mirrors
- 4. Check for voltage between the No. 9 terminal and body ground with the ignition switch ON (II). There should be battery voltage.
- If there is no battery voltage, check for:
- Blown No. 16 (7.5 A) fuse in the under-dash fuse/relay box.
- An open in the BLK/YEL wire.
- If there is battery voltage, go to step 5.
- If there is no battery voltage, check for:
- 5. Check for continuity between the No. 10 terminal and body ground.
There should be continuity.
- If there is no continuity, check for:
- An open in the BLK wire.
- Poor ground (G401, G402).
- If there is continuity, check both mirrors individually as described in steps 6 and Β 7 .
- If there is no continuity, check for:
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
