Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSHONDA2000INSIGHTREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCESYSTEMEVAP SYSTEMFTP SENSOR REPLACEMENT

2000 Honda Insight

FTP Sensor Replacement

2000 Honda InsightSECTION FTP Sensor Replacement

Remove the EVAP canister.
2000-2005 models: Remove the EVAP bypass solenoid valve (A) from the stay, then remove the FTP sensor (B).

Fig 1: Removing FTP Sensor (2000-2005 Models)
Courtesy of AMERICAN HONDA MOTOR CO., INC.
2006 model: Remove the clip (A) from the EVAP canister, then remove the FTP sensor (B).

Fig 2: Removing FTP Sensor (2006 Model)
Courtesy of AMERICAN HONDA MOTOR CO., INC.
2006 model: Install the new O-ring (C) in the sensor.
Install the sensor in the reverse order of removal.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.