Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Honda InsightFACTORY OEM SERVICE PROCEDURE
Ceiling Light/Spotlight Test/Replacement
- Turn the ceiling light/spotlights switches OFF.
- Carefully pry off the lens (A) with a small screwdriver.
CEILING LIGHT: 5W
SPOTLIGHT: 5W
- Remove the two screws and the housing (B).
- Disconnect the 4P connector (C) from the housing.
- Check for continuity between the terminals in each switch position according to the table.
- If the continuity is not as specified, check the bulbs. If the bulbs are OK, replace the light.
- When installing the ceiling/spotlights housing, if the thread in the ET screw is worn out, use an oversized ET screw made specifically for this application.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.