Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Honda Civic SiFACTORY OEM SERVICE PROCEDURE
Substituting Pcm
NOTE:
When replacing PCM, program new PCM and both Black and Gray ignition keys using Honda PGM Tester and Immobilizer program card.
- This procedure allows swapping PCM without having to program test vehicle's ignition key on a vehicle equipped with immobilizer system. Cut a temporary ignition key for test vehicle from a non-immobilizer key blank. Remove PCM from test vehicle.
- Write test vehicle's VIN on removed PCM to avoid confusion. Install known-good PCM in to test vehicle. Tape head of ignition key belonging to known-good PCM to head of temporary key. This will allow known-good PCM to recognize immobilizer code and allow engine to start using temporary key. After completing test, destroy temporary key.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.