1999 Honda Prelude Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Substituting Pcm

NOTE: Accord, Odyssey and Prelude utilizes an Immobilizer Anti-Theft system. If PCM is replaced, programming must be done with all keys (Black, Gray, and Red) present, using Honda PGM Tester and Immobilizer program card. See appropriate ANTI-THEFT SYSTEMS article in ACCESSORIES & EQUIPMENT.
  1. This procedure allows swapping the PCM without having to program test vehicle's ignition key on a vehicle equipped with immobilizer system. Cut a temporary ignition key for test vehicle from a non-immobilizer key blank. Remove PCM from test vehicle.
  2. Write test vehicle's VIN on PCM removed to avoid confusion. Install known-good PCM in to test vehicle. Tape head of ignition key belonging to known-good PCM to head of temporary key. This will allow known-good PCM to recognize immobilizer code and allow engine to start using temporary key. After completing test, destroy temporary key.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.