1995 Honda Prelude VTECFACTORY OEM SERVICE PROCEDURE

Distributor Sensors

Triggering of fuel injectors is dependent upon pulsed voltage signals generated by TDC/CKP/CYP sensors. For testing of these signals, see BASIC TESTING - 2.2L article.

TDC/CKP/CYL SENSOR RESISTANCE TEST

Application Terminals Wire Color
CKP Sensor Wire
1 Of 2 "B" Blue/Green
2 Of 2 "F" Blue/Yellow
CYL Sensor Wire
1 Of 2 "D" Orange
2 Of 2 "H" White
TDC Sensor Wire
1 Of 2 "C" Orange/Blue
2 Of 2 "G" White/Blue
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.