1995 Honda Prelude VTECFACTORY OEM SERVICE PROCEDURE

Passenger's Window Switch Test

Remove power window master switch. See procedures under MASTER POWER WINDOW SWITCHΒ  under REMOVAL & INSTALLATION. Using an ohmmeter, check resistance of switch terminals with switch in indicated positions. If continuity is not as specified, replace switch. See Fig 1 . See PASSENGER'S POWER WINDOW SWITCH TEST table.

PASSENGER'S POWER WINDOW SWITCH TEST

Position Pin Continuity
Off "B" & "C"; "D" & "E"
Up "A" & "D"
Down "A" & "C"
Fig 1: Passenger Power Window Switch Terminals
G94C46161Courtesy of AMERICAN HONDA MOTOR CO., INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.