Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Master Switch Test
Remove power window master switch. See procedures under MASTER POWER WINDOW SWITCHΒ under REMOVAL & INSTALLATION. Using an ohmmeter, check resistance of switch terminals with switch in indicated positions. If continuity is not as specified, replace switch. See Fig 1 . See POWER WINDOW MASTER SWITCH TEST table.
| Position | Main Switch | Pin Continuity | |||
|---|---|---|---|---|---|
| Driver's Switch | |||||
| Off | (1) | "B", "E" & "F" | |||
| Up | (1) | "F" & "G" | |||
| Down | (1) | "E" & "G" | |||
| Down (AUTO) | (1) | "E" & "G" | |||
| Passenger's Switch | |||||
| Off | On | "A", "I" & "J" | |||
| Off | Off | "I" & "J" | |||
| Up | On | "D" & "I"; "A" & "J" | |||
| Up | Off | "D" & "I" | |||
| Down | On | "A" & "I"; "D" & "J" | |||
| Down | Off | "D" & "J" | |||
|
|||||
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
