Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1995 Honda Odyssey EXFACTORY OEM SERVICE PROCEDURE
Electric Load Detector
- Unplug 3-pin ELD connector (located on right fender apron near underhood fuse panel). Turn ignition on. Measure voltage between Black/Yellow wire (+) and Black wire (-) at ELD connector. If battery voltage exists, go to step 3). If battery voltage does not exist, go to next step.
- Measure voltage between Black/Yellow wire and chassis ground. If battery voltage exists, repair open in Black wire between ELD connector and ground connection behind right kick panel. If battery voltage does not exist, repair open in Black/Yellow wire between ELD connector and No. 4 fuse (Accord and Odyssey) or ECM fuse (Prelude) in underhood fuse panel.
- Measure voltage in Green/Red wire between ELD connector and ground. If voltage is about 5 volts, go to next step. If voltage is not as specified, check for open or short in Green/Red wire between ECM and ELD connector. Repair wire as necessary.
- Turn ignition off. Reconnect ELD connector. Connect test harness between ECM and connectors. See Figure . Start engine and allow it to idle. While measuring voltage between terminals A26 and D10 of ECM connector, turn headlights on low beam. If voltage does not drop when headlights are turned on, replace ELD. If voltage drops, replace ECM with known-good unit. If voltage drop symptom disappears, replace original ECM.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.