Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1992 Honda Civic SiFACTORY OEM SERVICE PROCEDURE
Engine Mount Control System Solenoid Valve Test
- Warm up engine to normal operating temperature. Disconnect the upper vacuum hose from the solenoid valve. See Fig 1. Connect vacuum pump/gauge to upper vacuum hose. If there is intake manifold vacuum when the engine is below 750 rpm, go to next step. If there is no intake manifold vacuum, turn ignition switch OFF and disconnect the 2-pin connector from the solenoid valve. Connect battery positive to terminal A, and battery negative to terminal B of the solenoid valve. See Fig 1. Start the engine. If there is intake manifold vacuum, solenoid valve is OK, perform the CONTROL UNIT INPUT TESTΒ . If there is no intake manifold vacuum, replace the solenoid valve.
- Check for any vacuum when engine speed is above 700 rpm. If there is vacuum, perform the CONTROL UNIT INPUT TESTΒ . If there is no vacuum, solenoid valve and control unit are OK. Go to ENGINE MOUNT DIAPHRAGM ACTUATOR CHECKΒ .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
