1992 Honda Civic SiFACTORY OEM SERVICE PROCEDURE

Fuel Pump Main Relay Harness

  1. Turn ignition off. Disconnect main relay harness connector. Check for continuity between connector terminal No. 2 and chassis ground. See Fig 1. If continuity exists, go to next step. If continuity does not exist, repair open in Black wire from No. 2 terminal. See WIRING DIAGRAMS article in the ENGINE PERFORMANCE Section.
  2. Using a voltmeter, measure voltage between connector terminals No. 1 (positive) and body ground. See Fig 1. If battery voltage exists, go to next step. If battery voltage does not exist, check wiring between battery and main relay as well as ECU fuse in underhood relay box. Repair as required.
  3. Turn on ignition. Measure voltage between connector terminal No. 5 (positive) and body ground. See Fig 1. If battery voltage exists, go to next step. If battery voltage does not exist, check wiring from ignition switch and main relay. Check fuse No. 23 on Prelude, No. 2 on Accord or AGC on Civic (in dash fuse box). Check wiring from fuse box to main relay. Repair or replace as necessary.
  4. Connect voltmeter to connector terminals No. 6 (positive) and body ground. See Fig 1. Turn ignition switch to START position. If battery voltage is present, go to next step. If specified voltage is not present, check wiring between ignition switch and main relay. Check fuse No. 9. Check wiring from fuse box to main relay. Repair or replace as necessary.
  5. Connect a jumper wire between connector terminals No. 5 and No. 7. See Fig 1. Turn on ignition. Fuel pump should operate. If fuel pump fails to operate, check fuel pump wiring.
    Fig 1: Main Relay Harness Terminal ID (Accord Shown; Others Are Similar)
    G90I17150Courtesy of AMERICAN HONDA MOTOR CO., INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.