Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1992 Honda Civic SiFACTORY OEM SERVICE PROCEDURE
Power Circuits
- Using a voltmeter, check for battery voltage between ECU power terminal and ground. See POWER & GROUND CIRCUITS TERMINAL IDENTIFICATION table. See Fig 1. If battery voltage is not present, check appropriate ECU fuse in underhood fuse box. See ECU POWER CIRCUITS FUSE IDENTIFICATION table. If fuse is okay, check for an open in wire between underhood fuse box and appropriate ECU power circuit terminal.
- Turn ignition switch to ON position. Using a voltmeter, check for battery voltage between appropriate ECU power circuit terminal and ground. See POWER & GROUND CIRCUITS TERMINAL IDENTIFICATION table. See Fig 1. If battery voltage is not present, check appropriate fuse in underhood fuse box. See ECU POWER CIRCUITS FUSE IDENTIFICATION table. If fuse is okay, check for an open in wire between fuse box and appropriate ECU power circuit terminal or check for a defective ignition switch.POWER & GROUND CIRCUITS TERMINAL IDENTIFICATION
Application (1) ECU Terminal Ground Circuits A23, A24, A26 & B2 Power Circuits Ignition Switch In OFF Position D1 ON Position A25 & B1 (1) For terminal location identification, see Fig 1. ECU POWER CIRCUITS FUSE IDENTIFICATIONApplication (1) Fuse Accord & Civic Ignition Switch In OFF Position BACK-UP ON Position ECU Prelude Ignition Switch In OFF Position CLOCK ON Position EFI/ECU (1) All fuses are in underhood fuse box.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
