Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Engine Compression
Check compression pressure with engine at normal operating temperature, all spark plugs removed, throttle valves wide open and at specified cranking speed. Crank engine at least 6 revolutions to determine engine compression. Compression reading should be as specified in ENGINE COMPRESSION table.
| Model | Standard psi (kg/cm2 ) | Minimum psi (kg/cm2 ) | Minimum RPM | |||
|---|---|---|---|---|---|---|
| Accord | 178 (12.5) | 135 (9.5) | 250 | |||
| Civic & CRX | 185 (13.0) | 135 (9.5) | 250 | |||
| Prelude | ||||||
| Carbureted | 171 (12.0) | 135 (9.5) | 250 | |||
| Fuel Injected | 178 (12.5) | 135 (9.5) | 250 | |||
|
||||||
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.