1987 Honda Civic SiFACTORY OEM SERVICE PROCEDURE

A/C Switch Signal

Plug system checker harness between ECU and connector. Start engine. Turn blower switch and A/C switches "ON". Ensure compressor and condenser cooling fan are working. Connect voltmeter positive probe to terminal B8 (Blue/Red wire) and negative probe to terminal A18 (Black/Red wire). Voltage should be zero to 3 volts. If voltage is not within specification, check for open circuit in Blue/Red wire between A/C diode connector and ECU.

NOTE: Voltage should be above 9 volts, if compressor or condenser cooling fan stops when power is cut-off by pressure switch or thermostat.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.