1987 Honda Civic SiFACTORY OEM SERVICE PROCEDURE

Throttle Angle Sensor

Unplug throttle angle sensor connector. Measure resistance between Yellow/White and Green/White terminals on Prelude. On CRX Si models, measure resistance at Yellow/Red and Brown/Black terminals at sensor. Resistance should be 4000-6000 ohms on Prelude or 3200-7200 ohms on all other models. If resistance is outside specified range, adjust installation position of sensor and retest. Replace sensor if necessary.

Fig 1: Testing Throttle Angle Sensor Civic CRX Si models shown.
G42703
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.