Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1987 Honda Civic SiFACTORY OEM SERVICE PROCEDURE
Oxygen Sensor
- Unplug oxygen sensor connector. Start engine and run for 2 minutes at 3000 RPM under no load. Raise engine speed to 4000 RPM and release throttle suddenly at least 5 times.
- Within one minute after engine has been warmed up, measure voltage between connector terminal and body ground as outlined in steps 3) and 4).NOTE: If it takes more than one minute to complete checks, warm-up engine as outlined in step 1.
- Raise engine speed to 5000 RPM, and lower to 2000 RPM. Immediately turn ignition off. Voltage at terminal should be less than 0.4 volts. Disconnect vacuum hose No. 21 (hose between throttle body and MAP sensor on Civic CRX Si and Prelude), at throttle body. Plug throttle body fitting.
- Connect vacuum pump to open end of vacuum hose. Apply 12 in. Hg vacuum and raise engine speed to 4000 RPM. Voltage reading should be above 0.6 volts. Replace O2 sensor if voltages are not within specifications.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
