1987 Honda Civic SiFACTORY OEM SERVICE PROCEDURE

Idle Mixture Adjuster Sensor (IMA)

Open No. 1 control box. Remove rivets holding IMA sensor. Unplug IMA sensor 3-P connector. Measure resistance between Brown and Green terminals (Green and Yellow terminals on CRX Si) of IMA sensor while turning adjusting screw. Resistance should be 250-6200 ohms. Replace sensor if resistance is not within specifications. See Fig 1 .

Fig 1: Testing Idle Mixture Adjuster Sensor Civic CRX Si models shown.
G42701
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.