Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1987 Honda Civic SiFACTORY OEM SERVICE PROCEDURE
Fast Idle Control Solenoid Valve
NOTE:
The fast idle control solenoid valve is open when coolant temperature is less than 5°F (-15°C). If coolant temperature is less than 104°F (40°C), solenoid is open only when atmospheric pressure is less than 26 in. Hg. Vacuum is supplied to vacuum hose between solenoid valve and air flow tube.
- When valve is open, 9 volts or more should be available between Black/Yellow (Black on Civic CRX Si; Black/Yellow on Prelude) (A) and Blue/Black (Yellow on Civic CRX Si; Red/Green on Prelude) (B) terminals of control box No. 1 wiring harness.
- Disconnect wiring harness from No. 1 control box. Disconnect vacuum hose No. 18 from air flow tube (vacuum hose between fast idle control solenoid valve and No. 10 hose on CRX Si or No. 23 on Prelude). Apply vacuum to hose. Vacuum should hold constant. See Fig 1 .
- Connect battery positive terminal to Black (Black/Yellow on Prelude) terminal of No. 1 control box coupler, and battery negative terminal to Orange terminal (Yellow terminal on CRX Si). Disconnect vacuum hose No. 23 from intake manifold. Apply vacuum. Vacuum should not hold constant. If vacuum holds constant, replace valve.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
