Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1987 Honda Civic SiFACTORY OEM SERVICE PROCEDURE
Atmospheric Pressure Sensor (Pa Sensor)
- Unplug control unit wiring harness connector and install system checker harness. Turn ignition on. On all models except Prelude, connect digital voltmeter positive probe to C9 terminal of system checker harness. Connect negative probe to C12 terminal. Voltmeter should indicate 2.76-2.96 volts. See Fig 1 .
- If voltages are not within specifications, check for open or short circuit between ECU and atmospheric pressure sensor. Replace sensor if necessary.
- On Prelude, connect positive lead of digital voltmeter to C13 terminal and negative lead to C12 terminal. If voltage is not 4.75-5.25 volts, substitute with known-good ECU. If voltage is still not as specified, replace ECU. If voltage is as specified, connect positive lead to C9 terminal and negative lead to C12 terminal.
- If voltage is 2.76-2.96 volts, replace ECU. If voltage is not as specified, repair wiring between PA sensor and ECU. If wiring is okay, replace PA sensor.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
