Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1987 Honda Civic SiFACTORY OEM SERVICE PROCEDURE
Component Testing: THERMOSENSOR
- On Civic models, remove wires from thermosensor. Ensure engine is cold. Check for continuity to block below 167°F (75°C).
- Check for continuity to cylinder head below 131°F (55°C) on 1300 and High Alt. 1500 HF models or 149°F (65°C) on 1500 except HF models. Check for continuity to cylinder head below 113°F (45°C) on Federal 1500 HF models and below 122°F (50°C) on Calif. 1500 HF models.
- Warm-up engine to normal operating temperature. Check for no continuity to block above 167°F (75°C). Check for no continuity to cylinder head above 131°F (55°C) on 1300 and High Alt. 1500 HF models or above 149°F (65°C) on 1500 except HF models.
- Check for no continuity to cylinder head above 113°F (45°C) on Federal 1500 HF models and above 122°F (50°C) on Calif. 1500 HF models. Check for no continuity to cylinder head above 131°F (55°C) on 1300 models or 149°F (65°C) on 1500 models.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
