1987 Honda Civic SiFACTORY OEM SERVICE PROCEDURE

Civic 1500 HF Models

Check for voltage at control unit connector (Blue and Black/Yellow wires) with ignition on. If there is no voltage at Black/Yellow wire, check wiring. If there is no voltage at Blue wire, check wire between ignition coil and control unit. Check Black wire for continuity between control unit and ground. There should be continuity.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.