1987 Honda Civic SiFACTORY OEM SERVICE PROCEDURE

Air Valve

  1. On High Alt. 1300/1500 HF and Fed./High Alt. 1500 man. trans. except HF models, disconnect both No. 26 vacuum hoses from vacuum control valve and connect them together. On all models, disconnect air suction hose at air valve. See Fig 1 .
  2. If there is no vacuum present, proceed to step 4). If vacuum is present at air valve, disconnect hose No. 26 at air valve and check for vacuum at hose No. 26.
    Fig 1: Checking Air Valve Feel for vacuum.
    G36661
  3. If vacuum is present, replace control switch and retest. If there is no vacuum present, replace air valve and retest.
  4. Start engine and quickly raise engine speed to 3500 RPM. Close throttle suddenly. If there is vacuum, test is complete for 1500 except HF, or proceed to AIR CONTROL SOLENOID VALVEΒ  test on 1300/1500 HF.
  5. If there is no vacuum present, disconnect vacuum hose No. 26 from air valve. Check for vacuum at hose No. 26 during deceleration above 3500 RPM.
  6. If vacuum is present, replace air valve and retest. If there is no vacuum present, check vacuum line to intake manifold for leaks or blockage. If okay, replace control switch and retest.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.